Built-in Calibration with  Greyhound Datalogger

pH Sensor Calibration

EC Sensor Calibration

  • Firstly, Rinse and clean the sensor.

  • Connect Datalogger using SITEBOB Android Application vai Bluetooth

  • Put the pH sensor in known solution for more than 20 Seconds, in this example we used pH 7.00 solution.

  • Tap CALIBRATE SMR PH SENSOR

  • APP Reads pH sensor initially and displays current reading.

  • Tap CALIBRATE WITH pH 7.00 SOLUTION if you are using known solution pH 7.00, The APP starts the process of calibrating the sensor to pH 7.

  • After Calibration is completed new calibrated readings appear on the same screen with pH 7.0. if not redo the calibration again. Tap BACK to go to the main menu.

    Rinse the sensor and repeat with other solutions if necessary.

    Note:  If you wish to reset the sensor Tap FACTORY RESET pH SENSOR, All the sensor calibration offsets reset to default

  • Firstly, Rinse and clean the sensor.

  • Connect Datalogger using SITEBOB Android Application vai Bluetooth

  • Put the EC sensor in pure water for more than 20 Seconds

  • Tap CALIBRATE SMR EC SENSOR > Tap CALIBRATE WITH WATER

  • After calibrated with water put the EC sensor in to know a solution for more than 20 Seconds. Then Tab CALIBRATE TO KNOWN SOLUTION

  • The APP starts the process of calibrating EC Sensor to a known solution. And reads the sensor again

  • Finally, the App gives the calibrated values on the screen.